Results 1 to 6 of 6
Thread: Hello from The Netherlands
-
03-08-2013, 12:06 PM #1
- Join Date
- Mar 2013
- Location
- the netherlands
- Posts
- 3
Hello from The Netherlands
Hello,
My name is Michel and I'm 23 years old. I'm from The Netherlands so my English is not very good, I'm sorry for that. I'm building my own cockpit and started a year a go. Not much process till now. I'm trying to work with arduino to make my cockpit working.
Best regards,
Michel
-
03-08-2013, 12:16 PM #2
Re: Hello from The Netherlands
Hi Michel
Welcome to the forum,
Best Regards
-
03-10-2013, 08:31 AM #3
Re: Hello from The Netherlands
Hi Michel, welcome. Many Dutchies here so offline help is always near. What type of cockpit are you working on?
Arjen
-----
"There are only two things I can't stand in this world. People who are intolerant of other people's cultures... and the Dutch." (Nigel Powers in Goldmember)
-
03-10-2013, 09:28 AM #4
- Join Date
- Mar 2013
- Location
- the netherlands
- Posts
- 3
Re: Hello from The Netherlands
Hello,
I'm working on a Cessna 172. Two years a go I tried to join the Airforce but I didn't got further at the GVSS simulation test because of a really bad mistake what didn't had to happen. So I want to repeat the exercises, thats why I start building with a Cessna 172.
Best regards,
Michel
-
03-10-2013, 03:03 PM #5
- Join Date
- Mar 2011
- Location
- Tholen, Netherlands
- Posts
- 58
Re: Hello from The Netherlands
Hi Michel,
Welcome to the forum. I think 60% here builds a 737 sim including me but there are many Cessna builders too.
Where are you located in Holland?
Corné
-
03-10-2013, 03:17 PM #6
- Join Date
- Mar 2013
- Location
- the netherlands
- Posts
- 3
Re: Hello from The Netherlands
Hello Corné,
O yes, 737 is a dream for me. But I start small first so I can repeat my routines so I am a little bit more prepared when I will start with my PPL.
I'm just started again with working on my project. The only things I have now are the cessna panel, made from wood with all the wholes like the original. I have got my peddals and a yoke. But they are from CH products and old without USB so I will buy new parts soon. But first I want to finish my arduino so I can use it to drive the gauges with servos.
I'm located at The Hague.
Best regards,
Michel
Looking for fun companions for travels and adventures? Authentic Ladies Premier Сasual Dating
Top-notch Сasual Dating -...