Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Sep 2012
    Location
    Japan
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Flightdecksolutions MCP+ProjectMagenta Boeing GC+LEVEL-D+Lekseecon

    Hi,

    I have Flightdecksolutions MCP(FDS-MCP-NG) w/FDS-MCP-G2 interfacecard, ProgectMagenta MCP software, registered FSUIPC and WideFS.

    I use 2 PCs, one is for FSX(call it "FSX_PC), the other is for PM software("MCP_PC"). The former is Win 7 Pro 64bit, latter is Win XP.

    Normally, MCP hardware is connected with "MCP_PC", and I can control the AP of FSX's default airplanes via network with WideFS communication. There was no problem so far.
    Capture.JPG
    Recently, I purchased LEVEL-D and notified PM's MCP doesn't control LVL-D767, even I rotate course nob of MCP hardware, the course indicated on 767 panel never change...

    Then I googled and found fsconv, lekseecon for possible solutions.

    I put correct var in lekseecon_f.ini file and lekseecon_f.exe indicates he works well, no error msgs.

    Now I have a question, is there any possible solution to control LVL-D767 AP via networked PM software? How can I solve?

    I appriciate if anyone does know solutions or it can't be solved...


    Regards,

    KOMMY

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Flightdecksolutions MCP+ProjectMagenta Boeing GC+LEVEL-D+Lekseecon

    Hi KOMMY
    Forget PM software if you run Leveld. That does not work. The leveld has a fuly operational MCP. You can control that one via programs using FSUIPC OFFSETS and lekseecon_f or via SIOC and lekseecon. Both solutions are also available networked.
    Nico

  3. #3
    New Member
    Join Date
    Sep 2012
    Location
    Japan
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Flightdecksolutions MCP+ProjectMagenta Boeing GC+LEVEL-D+Lekseecon

    Thanks Nico for your reply.
    The point is, my MCP works well only with PM software, I suppose and experienced.

    Also did asked to PM support, they advised to use PM AP. It works, but strange behavior for, FLCH, A/T, N1, SPD.....

    I dreamed if lekseecon make it possible what I would.

    Anyway, thanks.

    KOMMY