Results 1 to 4 of 4
  1. #1
    75+ Posting Member
    Join Date
    Dec 2010
    Location
    Usa
    Posts
    94
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    New 0/16/16 Phidgets card

    On the phidgets board there is a 5V connection on either side of the board do you connect the pos power supply from your power source here and do you connect it to both sides so it picks up on both sides?
    Last edited by johnnyg; 06-27-2012 at 12:18 PM. Reason: more info

  2. #2
    300+ Forum Addict gokhotit's Avatar
    Join Date
    Oct 2004
    Location
    Tucson, AZ
    Posts
    314
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: New 0/16/16 Phidgets card

    I believe that ini file is for Project Magenta. That %V connector might be a power connector for switches, etc., I have older cards that require an outside power source to use.
    I'm not replicating anything, because I like to fly everything.
    http://www.youtube.com/watch?v=HG1LP3xxn0Q

  3. #3
    75+ Posting Member
    Join Date
    Dec 2010
    Location
    Usa
    Posts
    94
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: New 0/16/16 Phidgets card

    What about moving that one switch how is it done?Yes I figured out the power It is 5V and it runs off the usb port for applying power to the switches.

  4. #4
    75+ Posting Member
    Join Date
    Dec 2010
    Location
    Usa
    Posts
    94
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: New 0/16/16 Phidgets card

    Problem Solved
    Last edited by johnnyg; 06-27-2012 at 12:17 PM. Reason: more info