prosimparts radio modules

[stinger]

Thanks Ed it now works I hadn't done numerical config that was why! can I ask whats the difference with 1x 2x 4x on the encoder page and is 1x ok as you showed in your picture?
thnks again.

[cuevision]

Hi,

Good to hear you succeeded!

These numbers are used to fit in a correct rotation of your encoder knob. Just try it for your own needs. You shall see that the difference between them results in a fast and slower change of the display notation. I have set it up that it will change notation after 2 clicks of the knob (read encoder).

Does this make sense for you? Don't hesitate to ask.

Best regards!

[stinger]

Thanks that makes sense.