Results 1 to 3 of 3

Thread: Moving v5 to v4

  1. #1
    500+ This must be a daytime job



    Join Date
    Oct 2009
    Location
    Juneau, AK
    Posts
    553
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Moving v5 to v4

    Alan,

    I am using v5 right now. If I revert my files to v4, what will it do the functions that I have programmed in via valves, etc?

    What would I have to do to get everything working?

    Reid
    http://juneaucessnasim.blogspot.com
    N58243 (virtual)- Low and Slow...

  2. #2
    builder
    Join Date
    Jan 2007
    Location
    Texas
    Posts
    582
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FS2Phidget 5.0.21 hogging up to 25% CPU time with no outputs

    Reid,

    I would need to look at what circuits you have created.
    25% is high. How many cards are you running?
    Easiest would be to zip up xml files and send to me at alan@coconutair.com

    Regards,
    Alan

  3. #3
    500+ This must be a daytime job



    Join Date
    Oct 2009
    Location
    Juneau, AK
    Posts
    553
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FS2Phidget 5.0.21 hogging up to 25% CPU time with no outputs

    Alan,

    I have not experienced the cpu problem (at least have not noticed it.) Only running 1 card at the moment. May change in the next few days to an led card and a servo card.

    I just want to migrate to the most supported version of your software, but not reinvent the wheel. My file is only 237k. Do you need it zipped?

    Reid
    http://juneaucessnasim.blogspot.com
    N58243 (virtual)- Low and Slow...