Results 1 to 2 of 2
  1. 05-17-2012, 05:18 AM #1
    mrmaster
    mrmaster is offline
    150+ Forum Groupie mrmaster's Avatar
    Join Date
    Nov 2010
    Location
    Europe
    Posts
    164
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Poldragonet Overhead Annunciators Problem

    Hi,

    I just received the Poldragonet OVHD Kit but I am struggling with the Annunciators...

    How am I supposed to isolate them from the backlighting? Some fit into those nice holes (or square countersinks) that are completely painted and only have one (or two) small holes for the LED(s) but some (especially, but not only on the "white" panels") have completely transparent countersinks with the hole for the LED in it... Should I remove the panels and paint the countersinks or is there a "trick" to it?

    Thanks!

    Marc

    BTW: If you buy sthg from Poldragonet you get excellent (24-7) support from Jakub! Way different then some experiences I read about on this forum.. Maybe it's just because I bought one of the "big" products... who knows.
    "It is LEGEN... wait for it.... DARY" ARCOM_by_Marc
    Reply With Quote Reply With Quote
  2. 05-23-2012, 06:32 AM #2
    Imtryin
    Imtryin is offline
    25+ Posting Member
    Join Date
    Nov 2008
    Location
    Shropshire England
    Posts
    49
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Poldragonet Overhead Annunciators Problem

    I bought the MIP set from Poldragon. As with my KIT, you will probably find that you have to use a little glue here and a little paint there, but it will come together in the end. For the money, its not bad stuff, you just have to "make do" a little bit, thats all.

    Go ahead, if it solves the problem, use a little paint.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »