Results 1 to 4 of 4
Thread: Second Displays Card
-
04-30-2012, 04:12 PM #1
Second Displays Card
Hello everyone,
I have three master cards connected to a single USBExpansion Card as follows:
J1: In Use (DISPLAY CONNECTED)
J2: In use (DISPLAY CONNECTED)
J3: Not in Use
J4: In Use
So, on other words, there are two displays cards, connected to Master Cards #1 and #2.
The first display card works fine, however, I can't figure out how to configure the second (the one plugged into MC #2).
I have moved the Jumper pin to the "J3" position as per the manual, and have scripted the Displays as displays 16-31, also as per the manual.
Anything I've missed? The displays work fine when tested in Controlador.exe (ie they light up perfectly, so they definitely "work").
Cheers,
Jack
-
04-30-2012, 05:28 PM #2
Re: Second Displays Card
Hi Jack,
You can connect up to 4 Display cards to a Master Card. The numbering is described here.
Hope this helps.
regards,
Nico
-
04-30-2012, 05:29 PM #3
- Join Date
- Jul 2013
- Posts
- 917
Re: Second Displays Card
Edited as Nico had replied and given the correct answer, as opposed to mine
-
05-01-2012, 03:42 AM #4
Re: Second Displays Card
Extra: The jumper at a Display card determines the position in the row of 4 cards connected to a MC. You can put a card wherever you want (no special connect order).
Note that since SIOC 4.0 there is a tool called SIOC_Monitor. If you push the button ALL ON you can easily check whether the Display card works or not and by sending a number to a digit you can find out the numbering as well.
Nico
Looking for fun companions for travels and adventures? Authentic Ladies Premier Сasual Dating
Top-notch Сasual Dating -...