Results 1 to 3 of 3
  1. 02-20-2012, 07:22 PM #1
    rzoli86
    rzoli86 is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Feb 2012
    Location
    BUD, Hungary
    Posts
    5
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    737NG Landing Gear Control Panel measurements needed

    Hi Guys,

    I've decided to build the most realistic NG landing gear control assembly, but now I'm a bit confused because of the dimensions.
    I have three different sources with three different measurements, but in my case difference is not an option

    I need the "A" and "F" dimensions (check the attached photo).

    Few words about the project:
    - Full scale 1:1 replica
    - 3 position sensors to replicate the correct operation
    - Fully working lever lock solenoid
    - Fully working lock override
    - Front panel with intergrated backlight
    - Korry annunciator replicas
    - USB connection

    Thank you in advance,
    Zoltan
    737_1.jpg
    Reply With Quote Reply With Quote
  2. 02-21-2012, 02:38 AM #2
    oal331
    oal331 is offline
    300+ Forum Addict oal331's Avatar
    Join Date
    Dec 2006
    Location
    Athens - Greece
    Posts
    379
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 737NG Landing Gear Control Panel measurements needed

    My panel is 6 x 35 cm

    regards

    Eddie
    Eddie Armaos
    Athens-Greece

    [
    Reply With Quote Reply With Quote
  3. 02-21-2012, 08:26 AM #3
    rzoli86
    rzoli86 is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Feb 2012
    Location
    BUD, Hungary
    Posts
    5
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 737NG Landing Gear Control Panel measurements needed

    Thx Eddie, appreciated!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »