Results 1 to 4 of 4
Thread: Noobie Switch Question
-
01-21-2012, 03:14 AM #1
- Join Date
- Jan 2012
- Location
- USA
- Posts
- 3
Noobie Switch Question
Hey all! I'm trying to make some panels for the engine controls of the Turbine Duke, and there are several 3 position switches in this cockpit. I would like to use the Leo Bodnar interface cards for my setup. Is there a way to set up a 3 position switch with these cards?
I have seen On-Off-On switches, but my concern is that when I move the switch into the Off position, the sim will not recognize the command. I have also seen On-On-On switches, but have read on this site that they are incredibly difficult to wire, and not recommended.
Any advice on how to best get these swiches going would be much appreciated.
-
01-21-2012, 01:32 PM #2
Re: Noobie Switch Question
For a 3 position center off I would wire your two on positions to two consecutive inputs on the bodnar card and use FSUIPC4 to read them where you can assign a command to both the on and off action of each switch.
https://www.facebook.com/mycessnasim PC: Intel Core i7 Haswell @ 3.8GHz, 8Gb Ram, Win 7 64Bit, dual SSDs, GeFroce 780 SIM: P3Dv4.1, FSUIPC5, Link2FSMulti, ASN16, Orbix, REX, BFF Force Feedback
-
01-22-2012, 05:47 AM #3
- Join Date
- Jan 2012
- Location
- USA
- Posts
- 3
Re: Noobie Switch Question
I appreciate the response. It makes sense that would work, but having never done it, I wasn't sure if FSUIPC would recognize the Off position of the switch as a command.
-
01-22-2012, 05:51 AM #4
- Join Date
- Nov 2008
- Location
- Europe
- Posts
- 1,934
Re: Noobie Switch Question
FSUIPC would recognize ANYTHING that moves! Its that damn good!
GA or the Highway!
Candid connections: Platform for casual relationships Live Women Prime Сasual Dating
Super Сasual Dating - Genuine...