Results 1 to 3 of 3
  1. 12-01-2011, 09:38 AM #1
    notgotaclue
    notgotaclue is offline
    300+ Forum Addict notgotaclue's Avatar
    Join Date
    Nov 2010
    Location
    Wales
    Posts
    348
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Fly Engravity AFDS - Old Style with Converter - How to connect?

    Hi,
    I have the Fly Engravity AFDS - the old type with a converter to attach.
    I have a problem trying to connect this to the co-pilots side. I have connected the pilots side because the inputs were printed on the device, with this old style no inputs are printed so I have no idea where each wire goes. It also only has 16 input connectors rather than the 17 of the new version - this means I cannot just copy the way I have wired up the pilots side (which was a challenge in itself).
    Any help before I get any more grey hairs...
    Allan.
    Reply With Quote Reply With Quote
  2. 12-01-2011, 05:59 PM #2
    dnoize
    dnoize is offline
    500+ This must be a daytime job
    Join Date
    Nov 2005
    Location
    rotterdam, the Netherlands, Europe
    Posts
    804
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Fly Engravity AFDS - Old Style with Converter - How to connect?

    Allan,

    can you drop me an e-mail via FLYengravity ?
    I will dig up the manual for the old afds units.
    Reply With Quote Reply With Quote
  3. 12-01-2011, 06:29 PM #3
    notgotaclue
    notgotaclue is offline
    300+ Forum Addict notgotaclue's Avatar
    Join Date
    Nov 2010
    Location
    Wales
    Posts
    348
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Fly Engravity AFDS - Old Style with Converter - How to connect?

    Hi,
    Thanks for that, I have now been sent the manual from another user.
    Allan.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »