Results 1 to 4 of 4
  1. 11-08-2011, 06:11 PM #1
    pdpo
    pdpo is offline
    150+ Forum Groupie pdpo's Avatar
    Join Date
    Nov 2005
    Location
    belgium
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    SIOC 4 and the SIOC monitor

    Hi all,

    the new SIOC has the ability to get a window for each device where we can see the state of the buttons and leds of the
    card.
    However, when I open this window for my two master cards I can see some buttons in closed state and others which are
    closed too in reality doen show green. When I open and close those switches they appear green then. So it looks to me the initial
    state of the buttons is not always correct. Do you also see this behavior?

    Greetz Peter
    FS9+PM+AST+opencockpits
    Reply With Quote Reply With Quote
  2. 11-15-2011, 11:28 AM #2
    pdpo
    pdpo is offline
    150+ Forum Groupie pdpo's Avatar
    Join Date
    Nov 2005
    Location
    belgium
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: SIOC 4 and the SIOC monitor

    Nobody has tried this???
    FS9+PM+AST+opencockpits
    Reply With Quote Reply With Quote
  3. 11-15-2011, 12:13 PM #3
    kiek
    kiek is offline
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: SIOC 4 and the SIOC monitor

    Hello Peter,
    Have not tried it, but I'm not surprised. SIOC has exactly the same problem with some closed inputs that are not dedected by SIOC as closed inputs at start up. If you toggle these switches once they are in sync again.
    Groeten,
    Nico
    http://www.lekseecon.nl
    Reply With Quote Reply With Quote
  4. 11-15-2011, 12:13 PM #4
    kiek
    kiek is offline
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: SIOC 4 and the SIOC monitor

    Hello Peter,
    Have not tried it, but I'm not surprised. SIOC has exactly the same problem with some closed inputs that are not detected by SIOC as closed inputs at start up. If you toggle these switches once they are in sync again.
    Groeten,
    Nico
    http://www.lekseecon.nl
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »