Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. 10-03-2011, 02:04 PM #11
    notgotaclue
    notgotaclue is offline
    300+ Forum Addict notgotaclue's Avatar
    Join Date
    Nov 2010
    Location
    Wales
    Posts
    348
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 360 degree servos in analogue gauges

    Your spending well lately, have you sold the misses or something?
    Reply With Quote Reply With Quote
  2. 10-03-2011, 02:19 PM #12
    No Longer Active
    No Longer Active is offline
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,934
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 360 degree servos in analogue gauges

    Ive spent over £200 this weekend.

    £50 on my CH yoke, £45 for a LCD monitor foy my gauges to be displayed, £25 on an old P4 pc to run my gauges on a network, £110 for my plasma telly. About £10 on nuts, bolts, servos and other hardware etc.....

    I just needed to get a crack on with this sim, too much planning and not enough building!

    Ive got a partition going up in my garage soon for the sim room! (Studded wall, plaster board, air vents, lighting, the works!) That will be cool!
    GA or the Highway!
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »