Results 1 to 3 of 3

Thread: SICO Scripts

  1. #1
    150+ Forum Groupie mach7's Avatar
    Join Date
    Dec 2008
    Location
    Nova Scotia, Canada
    Posts
    172
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hello all,

    I would first like to thank everyone who has helped me so far in my search for cockpit 'realism'.

    A special thank you goes out to 737Nut and Mike Powell for all the help and continued support so far.

    Just wondering if there are SIOC scripts readily available to interface with an Open Cockpits USB card.

    I am considering going the stepper motor route as opposed to a servo motor to replace the exsisting drive in my engine gauges.

    I am also considering using Open Cockpits USB stepper board for the interface.

    I am wondering if there are already written scripts for N1, N2, EGT, Fuel flow, etc.

  2. #2
    300+ Forum Addict



    Join Date
    Feb 2007
    Location
    California, USA
    Posts
    406
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: SICO Scripts

    Jim, your PM mail box is full and bouncing messages.

  3. #3
    150+ Forum Groupie mach7's Avatar
    Join Date
    Dec 2008
    Location
    Nova Scotia, Canada
    Posts
    172
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: SICO Scripts

    Thanks Mike,

    Should be good to go now