Results 1 to 2 of 2
  1. #1
    500+ This must be a daytime job 737NUT's Avatar
    Join Date
    Feb 2006
    Location
    Indianapolis, IN
    Posts
    778
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Need some help with a perplexing issue in SIOC

    When running SIOC, my USB expansion stops responding after a 1-5min delay. It shows up in the box in SIOC but nothing happens when i flip switch. No led indication on board or in iocp console. If i test the card through controlador program, it functions fine for over an hour. Also, this is intermettent, sometimes all works fine for several hours. Very strange but i have narrowed it down to SIOC stops communicating with the usb expansion and locks the card up. If unplug usb connector and reconnect, all is ok sometimes and others it will stop responding after a min or two. Again, it works perfect through controlador test program.

    thanks,
    Rob

  2. #2
    Our new friend needs to reach 10 posts to get to the next flight level CanberraACT's Avatar
    Join Date
    Nov 2009
    Location
    Australia
    Posts
    9
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Need some help with a perplexing issue in SIOC

    Only time I had a problem like that was when I had something plugged into USB sockets on the front of an older PC. Turned out they were original USB1 ports and the item was expecting to be plugged into USB2 ports (which I had at the back of the machine). Things would work OK for a short time and then stop talking.