Results 1 to 2 of 2
  1. #1
    300+ Forum Addict skino's Avatar
    Join Date
    Nov 2008
    Location
    germany
    Posts
    349
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Help with little (?) Sioc-Problem

    I want to insert into this sioc code (compass), a key inquiry. "+" Key rotates one position to the right, "-" key on to the left. So I would like to adjust the USB-compass after power on with the position of the compass on the simulator


    // *****************************************************************************
    // * Config_SIOC ver 3.7B1 - By Manolo Vélez - www.opencockpits.com
    // *****************************************************************************
    // * FileName : 360.txt
    // * Date : 13.07.2011



    Var 0000 // Motor 1 Data

    Var 0015, Link FSUIPC_IN, Offset $02CC, Length 8, Numbers 1 // FSimulator Compass
    {
    L0 = V0015 + 1460 // Add 146 degree for my gauge center
    IF L0 > 3600 // If is > 360 degree discount a full turn
    {
    L0 = L0 - 3600
    }
    V0000 = L0 // send degrees to steper motor"

    *****************************************************************************

  2. #2
    25+ Posting Member
    Join Date
    Jan 2008
    Location
    Sydney, Australia
    Posts
    29
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Help with little (?) Sioc-Problem

    So would you like to do "key inquiry" or initialize position of the hardware after power-on?