Results 1 to 3 of 3
  1. #1
    25+ Posting Member
    Join Date
    Oct 2010
    Location
    Perth
    Posts
    52
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Flap gauge, left and right values

    Hi everyone,
    Not sure if this has been answered before, but i did a few searches but could find any info.
    I purchased a dual pointer flap gauge from simkits, but the set-up only seems to have one flap function, and not two (left and right.)
    Im a bit confused because i cant see the point in having two needles, with only one funtion. Can someone shed some light on this, or give me a link?

    Thankyou,
    Regards
    TOM

  2. #2
    75+ Posting Member
    Join Date
    Nov 2008
    Location
    seattle
    Posts
    140
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Flap gauge, left and right values

    Hi, page 17 of Pete Dawsons offset list says 0BE0 left flap position, 0BE4 right flap position.

    you should go get this file at http://www.schiratti.com/files/dowson/FSUIPC_SDK.zip

    inside there you will see the file "FSUICP4 offset status.pdf"
    every offset FS uses

    Andy

  3. #3
    25+ Posting Member
    Join Date
    Oct 2010
    Location
    Perth
    Posts
    52
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Flap gauge, left and right values

    Thanks Ian,
    I was hoping that the left and right funtions would already be incorperated into the simkits setup software.
    I havent had much to do with SDK, and it looks like i will need to learn a whole lot more, just to get the two needles working oh well.
    Thankyou
    Tom