Results 1 to 5 of 5
  1. #1
    25+ Posting Member
    Join Date
    Jul 2010
    Location
    Finland
    Posts
    35
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    About to start building

    Hello!

    I got overhead light switch panel prints, what would be the best way to fit them on each other precisely and stick them between two sheets of plexiglass?

    Also, should I sand the plexi behind mask for light to spread, and what thickness of it I need for back and front?

    Image of the prints:
    http://s529.photobucket.com/albums/d...t=IMG_1718.jpg

    Thanks!

  2. #2
    25+ Posting Member
    Join Date
    Jul 2010
    Location
    Finland
    Posts
    35
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: About to start building

    Anyone knows something useful?

  3. #3
    150+ Forum Groupie
    Join Date
    Oct 2010
    Location
    norway
    Posts
    180
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: About to start building

    you can use in front 1mm plexiglass and 3mm plexiglass in the back

  4. #4
    25+ Posting Member
    Join Date
    Dec 2008
    Location
    Poland
    Posts
    30
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: About to start building

    should I sand the plexi behind mask for light to spread
    'Sand the plexi' could do, but better is to use a milk plexiglass. It spreads the light more evenly.
    I hope you succeed with your idea, but something tells me sooner or latter you'd end up with engraved panels.
    This print-and-glue-the-panel method rarely gives nice and fine results.

  5. #5
    25+ Posting Member
    Join Date
    Jul 2010
    Location
    Finland
    Posts
    35
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: About to start building

    How much do they cost? I've seen quite many succesfull panels made with plexi and prints.