Results 1 to 4 of 4
  1. #1
    500+ This must be a daytime job Sean Nixon's Avatar
    Join Date
    Jun 2008
    Location
    EGNT
    Posts
    678
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    USB via CAT5 and patch panel?

    Scenario...

    Cut a USB cable in half.

    Put an RJ45 onto each cut end.

    Plug 1st cable into PC and patch panel.

    Plug 2nd cable into RJ45 outlet and USB device.

    Has anyone tried this? I'm aware of the 5 metre limitation on USB cables, but other than that, I can't think why it shouldn't work.

    Sean

  2. #2
    500+ This must be a daytime job
    Join Date
    Nov 2005
    Location
    rotterdam, the Netherlands, Europe
    Posts
    804
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: USB via CAT5 and patch panel?

    Dont know why you would want to do that ?

    For those having problems with the USB 5 meter limit: There are usb extenders available. this is a set of converters which you can connect with CAT5 cables over a lenght of up to 150 feet. Should be enough for most sims

    Used them many times and work without a problem.

    http://cgi.ebay.com/USB-Cat5-RJ45-La...item2563957cfb


    Stef
    www.boeing737ng.com
    ___________________________
    The Dutch 737 Simulator Project

  3. #3
    500+ This must be a daytime job Sean Nixon's Avatar
    Join Date
    Jun 2008
    Location
    EGNT
    Posts
    678
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: USB via CAT5 and patch panel?

    They are a neat idea. Thanks for the link Stef.


    Sean

  4. #4
    150+ Forum Groupie skino's Avatar
    Join Date
    Nov 2008
    Location
    germany
    Posts
    299
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: USB via CAT5 and patch panel?

    http://www.usb-over-network.com/usbn...ns/remote.html

    I use this software to a USB webcam. It creates a virtual USB port, just like a real work.
    Trial Version available.

    http://www.usb-over-network.com/downloads.html