Results 1 to 3 of 3
Thread: Hello
-
05-07-2011, 01:17 PM #1
- Join Date
- Apr 2011
- Location
- Canada
- Posts
- 2
Hello
Hey,
New member from Canada here. A quick hello and thanks for the help.
I have almost finished my little portable console. I dont have the room for a full pit so I thought I's experiment with a little portable one. Used Leos card and created this. I do mostly GA flights (thus the water rudder switch) I still have to finish the landing gear lever cap but it essentially works now.
A few resistors enabled me to use the light up switches, and the red LED is just a plugged in light (to make sure the panel is connected). I used 31 out of leos 32 connections, and a the dial. All knobs are push buttons for activation in the AP
Couldn't have done it without reading these forums so thanks again !
Here are a couple of shots...(still working on the panel cover so its just temp written for now) Also noticed that I labeled the Landing Gear Lever as a parking break lever....its LANDING GEAR
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 DislikesMatt Olieman, Joe Cygan thanked for this post
-
05-07-2011, 05:13 PM #2
Re: Hello
Clever and unique!!! Nice job and thanks for sharing your project.
Matt Olieman
-
05-07-2011, 05:25 PM #3
- Join Date
- May 2006
- Location
- Texas
- Posts
- 616
Re: Hello
You gotta love it!