Results 1 to 3 of 3

Thread: Hello

  1. #1
    New Member
    Join Date
    Apr 2011
    Location
    Canada
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hello

    Hey,
    New member from Canada here. A quick hello and thanks for the help.
    I have almost finished my little portable console. I dont have the room for a full pit so I thought I's experiment with a little portable one. Used Leos card and created this. I do mostly GA flights (thus the water rudder switch) I still have to finish the landing gear lever cap but it essentially works now.
    A few resistors enabled me to use the light up switches, and the red LED is just a plugged in light (to make sure the panel is connected). I used 31 out of leos 32 connections, and a the dial. All knobs are push buttons for activation in the AP
    Couldn't have done it without reading these forums so thanks again !

    Here are a couple of shots...(still working on the panel cover so its just temp written for now) Also noticed that I labeled the Landing Gear Lever as a parking break lever....its LANDING GEAR


  2. Thanks Matt Olieman, Joe Cygan thanked for this post
  3. #2
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    3,155
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Hello

    Clever and unique!!! Nice job and thanks for sharing your project.

    Matt Olieman

  4. #3
    Super Moderator
    Join Date
    May 2006
    Location
    Texas
    Posts
    654
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Hello

    You gotta love it!