Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Jul 2010
    Location
    Paris
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Opencockpits FMC 737 used for 767 and Lekseecon ?

    Hello from Paris France,

    My LVLD767 works fine with MCP and EFIS and Lekseecon for a long time.
    Thank you again for this very good work.

    I just received a FMC737 from Opencockpits (plug and play).

    But unfortunately, it doesn't work (Lekseecon and Sioc run without problem and all is well configured).

    I used the ocm/fmc\fmc.ssi as written in this forum.
    Does it works with OC FMC737 or only for a FMC747 ?
    Is there a solution to use my FMC737 ?

    Thank you by advance for your help.
    Best regards
    Thierry

  2. #2
    500+ This must be a daytime job Boeing 747 Flyer's Avatar
    Join Date
    Nov 2009
    Location
    England
    Posts
    771
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Opencockpits FMC 737 used for 767 and Lekseecon ?

    Hi Thierry,

    I think that it would only be for a 747CDU. This is because a 737 CDU is quite different to a 767 in terms of key layout. Although, maybe you could adjust the inputs to your preference.

    Jack

  3. #3
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Opencockpits FMC 737 used for 767 and Lekseecon ?

    Bonjour Thierry,
    Quote Originally Posted by careidas View Post
    I used the ocm/fmc\fmc.ssi as written in this forum.
    Does it works with OC FMC737 or only for a FMC747 ?
    Is there a solution to use my FMC737 ?
    The fmc.ssi script is for the FMC747 so it will not work out of the box for a FMC737, although some keys might still work (also check your sioc.ini, did you add USBKEYS?)

    However, it must be possible to adjust the inputs.
    Run IOCKeys.exe, push each button and note the number connected to each key.
    Then take my FMC source (The SIOC script) available in ocm\fmc and change the inputs if needed, then recompile.

    regards,
    Nico