Results 1 to 3 of 3
  1. #1
    75+ Posting Member


    Clive's Avatar
    Join Date
    Feb 2009
    Location
    Newcastle Upon Tyne UK
    Posts
    100
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Engine and spur valve blue annunciators

    Hi

    I have so far not been able to get the engine and spur cut off valves to show on my overhead, however, I just discovered something while experimenting with PM Systems ..... I can get the blue engine and spur valve lights to function in the overhead if I use the software engine cut off valves using a mouse to switch them on and off.
    My hardware engine cut off valves on my Revolution Sim Products throttle are recognised by PM Glass cockpit and function OK but are not seen by PM Systems.
    Do you know what I need to do to get PM Systems to recognise the hardware engine cut off levers??

    Regards

    Clive ****inson

  2. #2
    500+ This must be a daytime job Sean Nixon's Avatar
    Join Date
    Jun 2008
    Location
    EGNT
    Posts
    713
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine and spur valve blue annunciators

    I've got all this to come Clive, my overhead just turned up!

  3. #3
    25+ Posting Member
    Join Date
    Mar 2007
    Location
    Stockholm, Sweden
    Posts
    71
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Engine and spur valve blue annunciators

    This behavior have many TQ:s.

    The cut off valves send the information to FS cut off instead of to PM cut off.

    Can possibly be fixed with disconnecting them and reconnect with a card (Bodnar or other) that triggers PMsystem offsets for fuel cut off.
    PM Cut off then sends their on/off positions to FS. Without routing the cutoffs via PMsystem SPAR valves will not "work" in the overhead panel.
    I have not yet done so myself, but will try that soon.

    Bjorn