Results 1 to 3 of 3
  1. #1
    New Member
    Join Date
    Jan 2011
    Location
    UK
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    lekseecon and LevelD 1.4.2a

    Hi Nico

    I have just purchased levelD 767 and it automatically comes with service pack 2 so it's version is 1.4.2a, when i run lekseecon and then fsx, Lekseecon comes with an error 11 saying that it needs version 1.4.

    I'm also using Lekseecon version 7.2

    Is this something i have done wrong, or is Lekseecon not compatible with this version yet?

    Regards
    Paul

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,200
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: lekseecon and LevelD 1.4.2a

    Hi,
    It should work...
    Check your settings.
    Start FSX first, then SIOC, then lekseecon
    Nico

  3. Thanks ufo_101 thanked for this post
  4. #3
    New Member
    Join Date
    Jan 2011
    Location
    UK
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: lekseecon and LevelD 1.4.2a

    Ah, i was starting sioc then lekseecon and then fsx, all working now

Similar Threads

  1. OC Efis leveld
    By smartarze in forum lekseecon Q&A and Discussions
    Replies: 2
    Last Post: 10-01-2010, 01:13 PM
  2. Lekseecon error#3 lekseecon.ini not found
    By bsv118 in forum OpenCockpits General Discussion
    Replies: 3
    Last Post: 05-11-2009, 03:56 AM
  3. SIOC and LevelD 767
    By bsv118 in forum OpenCockpits General Discussion
    Replies: 1
    Last Post: 05-05-2009, 09:13 AM
  4. LEVELD on two computers, possible?
    By stabell in forum Computer Hardware Setup
    Replies: 7
    Last Post: 10-31-2008, 09:18 PM