Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie
    Join Date
    Jul 2008
    Location
    Belgium
    Posts
    279
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Experimenting with the laser for panel engraving

    Hello,

    Since a few weeks I have access to a laser so I can experiment engraving/cutting panels with the laser.

    The first results are promising but I still need to learn a lot to make it a 150% perfect panel. Below the results of this week. The first 2 pictures show you the laser in action.

    Enjoy, Wendy








  2. #2
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    201
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Experimenting with the laser for panel engraving

    Hi Wendy,

    Looks great!!!

    Have you connected the Laser to your CNC machine?
    If so, can you post some pictures of the laser?

    Best regards

    Jan Geurtsen

  3. #3
    150+ Forum Groupie
    Join Date
    Jul 2008
    Location
    Belgium
    Posts
    279
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Experimenting with the laser for panel engraving

    That was the thing I would have liked the most (just put a laserhead on top of it), but the CNC is not suited for that.
    No it has nothing to do with my CNC, it is just a separate machine. It's a LaserPro with 30 Watt power.


    Regards, Wendy

Similar Threads

  1. Laser vs Router Engraving
    By Atomic_Sheep in forum CNC Discussion
    Replies: 36
    Last Post: 11-17-2014, 05:16 PM
  2. My first laser cut panel
    By glider_uk in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 12-16-2010, 03:05 PM
  3. Laser Engraving and material selection
    By Tomlin in forum Where to Start Building a Home Cockpit
    Replies: 17
    Last Post: 09-02-2010, 05:00 PM
  4. Laser engraved back lit panel suppliers
    By turbopropdriver in forum General Builder Questions All Aircraft Types
    Replies: 15
    Last Post: 04-09-2010, 09:21 AM
  5. Laser engraving/cutting recommendations
    By Shawn in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 12-03-2008, 09:09 PM

Tags for this Thread