Thread: Instruments & FSpanelStudio
11-03-2010, 09:32 AM #1
Instruments & FSpanelStudio
I am curious to know if you can adapt a downloaded engine gauge...copy it in FS panel Studio, then change its configuration to become engine 4 as opposed to engine 1, 2, or 3.
Here is my problem.
I have found the style and type of engine gauges downloaded from a DC10 panel. I want to use these gauges in a four engine application...therefore want to copy one set of gauges and identify them to recognize the additional engine.
Thanking everyone in advance.
By mab1990 in forum General Builder Questions All Aircraft TypesReplies: 2Last Post: 03-06-2010, 07:14 AM
By Captain825 in forum Computer Hardware SetupReplies: 2Last Post: 11-13-2009, 08:03 AM
By props in forum Computer Hardware SetupReplies: 4Last Post: 10-09-2009, 04:05 AM
By airbus340 in forum General Builder Questions All Aircraft TypesReplies: 3Last Post: 07-27-2009, 09:17 AM
By 747sim in forum General Builder Questions All Aircraft TypesReplies: 12Last Post: 08-04-2008, 08:40 PM