Results 1 to 2 of 2
  1. 10-20-2010, 05:58 AM #1
    bagarie
    bagarie is offline
    25+ Posting Member
    Join Date
    Feb 2008
    Location
    Italy
    Posts
    70
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    USB Out Led dimming

    Hi,

    there is a way to Dimming just some Leds on the Usb card OC and not all togheter?
    What0s the correct syntax on SIOC?
    I need because I use that with Prosim, for dimming some annunciators like Fuel Valve, Eng Aice ecc. ecc.

    Thanks
    Arnaldo
    Reply With Quote Reply With Quote
  2. 10-20-2010, 06:12 AM #2
    fordgt40
    fordgt40 is offline
    500+ This must be a daytime job


    Join Date
    Jul 2013
    Posts
    917
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: USB Out Led dimming

    Arnaldo

    You can have a dimmed state for the overhead valve annunciators by using two outputs, ie you connect the led(s) via two different value resistors to two separate outputs. The "dimmed" state would have the higher resistor value. You would also need to put two diodes in the circuit. I have done this on my overhead - it is easier than it sounds!

    If you are interested I will try to find a circuit diagram

    David
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Dimming the lower EICAS/ECAM
    By jb747 in forum PM Boeing GC
    Replies: 0
    Last Post: 06-08-2008, 05:51 PM
  2. Dimming Project Magenta displays ...help!
    By luker in forum FS2Phidget Users
    Replies: 22
    Last Post: 10-14-2005, 05:42 AM