Results 1 to 2 of 2
  1. 08-22-2010, 06:52 AM #1
    No Longer Active
    No Longer Active is offline
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,934
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Diameter of CH Yoke shaft?

    Hi,

    Can someone please tell me what the panel cut out size is for the CH yoke shaft?

    I am assuming it is just under 3cm?

    Kind Regards,

    Alex
    GA or the Highway!
    Reply With Quote Reply With Quote
  2. 08-22-2010, 10:17 AM #2
    Neil Hewitt
    Neil Hewitt is offline
    150+ Forum Groupie


    Neil Hewitt's Avatar
    Join Date
    Jan 2010
    Location
    London, UK
    Posts
    205
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Diameter of CH Yoke shaft?

    Hi Alex.

    The shaft for the standard CH yoke is 25mm in diameter.

    NH
    Reply With Quote Reply With Quote
  3. Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
    Thanks No Longer Active thanked for this post
« Previous Thread | Next Thread »

Similar Threads

  1. Elma E37 dual shaft encoders to Open Cockpit cards - hardware convertor
    By Leo Bodnar in forum I/O Interfacing and Hardware
    Replies: 1
    Last Post: 01-09-2011, 11:52 PM
  2. What rotary encoder shaft length is the best for you? Poll...
    By Leo Bodnar in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 12-20-2010, 05:44 AM
  3. Yoke height and diameter of control column?
    By HondaCop in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 09-03-2010, 08:18 PM
  4. Cessna Yoke Column - Yoke Movement ?
    By Ronson2k9 in forum General Aviation (GA) Builder Disccusion
    Replies: 2
    Last Post: 04-20-2010, 12:09 PM
  5. New dual-shaft concentric encoders with pushbutton from ELMA available
    By Leo Bodnar in forum I/O Interfacing Hardware and Software
    Replies: 2
    Last Post: 04-29-2009, 12:25 PM