Results 1 to 3 of 3
  1. #1
    10+ Posting Member
    Join Date
    Apr 2010
    Location
    Poland
    Posts
    17
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    FSBUS i/o card - resistor connect in series

    Hello
    I am making a FSBUS i/o card. I can't get seven 100 ohm resistors "pack" (connect in series) so I have one question:
    Should I use this elements or not?

    In instruction We can read: "The resistance can vary between 0 ohm and 100 ohm"
    If resistors could have 0 ohm i must not use this resistors ...

    I don't understand..
    Why this elements are installed on pcb in instruction?

  2. #2
    300+ Forum Addict
    Join Date
    Feb 2008
    Location
    Krefeld, Germany
    Posts
    318
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FSBUS i/o card - resistor connect in series

    Hi,

    is it right that you mean RA1 to RA7?
    If you don磘 have that Resistor Array, than use cable connections or something like that.
    The only reason for that Resistors are, that is the easiest way to solder that part on the PCB.

    Stefan

  3. Thanks adacho thanked for this post
  4. #3
    10+ Posting Member
    Join Date
    Apr 2010
    Location
    Poland
    Posts
    17
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: FSBUS i/o card - resistor connect in series

    Thanks for Help sgaert
    I'm going to connect wholes using cables

Similar Threads

  1. How many encoders I can connect to FSBUS?
    By adacho in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 05-22-2010, 08:37 AM
  2. LED resistor placement
    By mterm in forum I/O Interfacing and Hardware
    Replies: 2
    Last Post: 04-09-2009, 08:34 PM
  3. where can I find FSBUS card kits
    By mnovak22 in forum I/O Interfacing Hardware and Software
    Replies: 10
    Last Post: 02-10-2009, 05:31 PM
  4. Powering LED's : use a resistor or not?
    By shawnpwilson in forum Phidgets & Cockpit Simulator Builder
    Replies: 1
    Last Post: 01-18-2005, 06:21 AM