Results 1 to 2 of 2

Thread: panel qestion

  1. #1
    150+ Forum Groupie spiro's Avatar
    Join Date
    Jan 2009
    Location
    greece
    Posts
    286
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    panel qestion

    hello every one
    i have some second hand panels that are a bit scratched and staind
    i would like to ask how can i clean them up without recking them
    or damaging them????

    any ideas????

    regards

  2. #2
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,934
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: panel qestion

    Hi Spiro.

    If a panel is scratches, it will take some effort to blend them out again, you will have to match the colour and it will be hard to blend them back in again. Stains will be impossible to remove unless you take off the entire coat of paint and repaint, if you have engraving then this will probably need to be infilled - unless you can apply the paint to the surface of the panel without it infilling the engraving.

    Just give it your best shot mate, do your best, you never know how it will come out.

    Just work on small areas at a time!

    Is the MIP? or other panels? Glare? Pedestal?

    Cheers,

    Alex
    GA or the Highway!

Similar Threads

  1. off set qestion??
    By spiro in forum I/O Interfacing and Hardware
    Replies: 2
    Last Post: 07-22-2010, 03:12 AM
  2. MIP qestion
    By spiro in forum General Builder Questions All Aircraft Types
    Replies: 18
    Last Post: 03-26-2010, 03:15 PM
  3. panel push buttons qestion
    By spiro in forum I/O Interfacing and Hardware
    Replies: 2
    Last Post: 10-24-2009, 04:15 PM
  4. Ga sim qestion
    By spiro in forum General Aviation (GA) Builder Disccusion
    Replies: 4
    Last Post: 08-23-2009, 06:34 AM