Results 1 to 2 of 2
  1. #1
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Old: COMM1 question

    Maybe you are able to answer this question: I am trying to run Squawkbox 4 from another coputer in my network. (FSX)

    Everything works with the default cessna: when tuning comm1 to the controllers frequency, I "get contact" with him on the remote computer. But with the LevelD, the COMM1 frequency doesn't seem to be passed through the network via simconnect.

    I check with sioc console that the correct numbers (bcd) is written to the FSUIPC variable, so I cannot seem to find out why the radio is not working on the leveld, but on all default aircraft.
    You say that the comm1 frequency is written via simconnect to the leveld panel, do you happen to know why simconnect are unaware of the comm1 frequency?
    (I thought maybe there were som special vars to use, or something)

  2. #2
    2000+ Poster - Never Leaves the Sim kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    2,202
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Old: COMM1 question

    For your info, I just found out what was the problem with the LevelD Comm problem. It turns out that the elec hydraulic pumps must be on for the radios to work!
    I have no idea why

Similar Threads

  1. Looking for a generic comm1 script
    By djcevera20 in forum OpenCockpits General Discussion
    Replies: 3
    Last Post: 11-04-2009, 03:09 PM