Whats the Transponder OFFSET?

[388TH_A]

Are you saying do that because that also doesnt work. So i was able to get my knob to change the SquawkBox Transponder from STBY to NORM and then back to STBY. But every time i push the IDENT button it doesnt show any thing in the lil window in SquawkBox so there for it could be working but not sure

		case C_SXPNDRIDENT:
			if (val ==0)
			{
				FsWrite (FS_XPNDRIDENT, 1);
			}
            break;

[sgaert]

ok. Look with FSInterrogate2std.exe to the offset.
If you see the value 1 flashing you send the right command.

[388TH_A]

LOL i aready did and there isnt a 7000 range in there lol other wise i would have know for sure if it worked lol but thanks for the idea

[sgaert]

you can enter every offset you like in FSInterrogate2std.exe.
The table are only the published default offsets of the FS.
And SB isn´t a part of the FS.

Go to the Interrogate screen.
Enter in the fields From Addr: and To: your Offset.
The field Known / Unknown Variables: you change to Both (Byte-Align).
Than press Setup Fields.
Now you can see the Offset in the table.
On the botton of the page you check the Hide Progressbar and Continues Checkboxes.
Now you see what happends on the Offset.

[388TH_A]

NICE THANKS it works but..... guess i have to hit the button over and over again for it to work. Dont get me wrong it works but just for a brief sec when you push it. Am i able to change it to where i hit the button it can be on a timer then go back to the value of 1? just hate pushing the button over and over again for 5 secs to make it ident long enough.

[sgaert]

From the SQ SDK

0x7b93
Transponder Ident pressed. When the user presses the ident button on your transponder gauge, you should set this value to 1. When SquawkBox notices it is set to 1, it will transmit an ident on the network and reset the value to 0.

[388TH_A]

right but had a Controller tell me that it only would work when i hit the button over and over again and then if i hit it 1 time its on for a brief sec. but again thanks got it to work

[sgaert]

ok, that is intersting.
I use FSInn and only send 1 time the impuls to the Client.

[388TH_A]

then maybe i should use FSINN andon top of that the other aircraft do show up better any ways

[388TH_A]

couldnt i put a MkTimer on it so that i can push the Button one time instead of over and over again?