Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12
  1. 04-13-2010, 06:59 AM #11
    ian@737ng.co.uk
    ian@737ng.co.uk is offline
    500+ This must be a daytime job
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100
    ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    609
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Leo Bodnar still in business?

    g'morning captain.......
    not so much drivers as a utility. i think you probably mean the encoders config software.
    used to set button pairs to see rotary encoders to give repeated button presses in the
    direction of rotation of the encoder. brilliant !!!
    have a great day......

    ian.

    p.s. looks like the Main Man beat me to it
    Last edited by ian@737ng.co.uk; 04-13-2010 at 07:00 AM. Reason: addition
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge
    Reply With Quote Reply With Quote
  2. 04-13-2010, 08:31 AM #12
    Boeing 747 Flyer
    Boeing 747 Flyer is offline
    500+ This must be a daytime job Boeing 747 Flyer's Avatar
    Join Date
    Nov 2009
    Location
    England
    Posts
    635
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Leo Bodnar still in business?

    Quote Originally Posted by Leo Bodnar View Post
    This is just a configuration utility for rotary encoders if you use them.
    If you only use pots and switches then you won't need it.
    Okay that's great. I plan to use your card to make a section of a B757 ovheread panel, which is mainly switches and 3 position switches. However, there are a few 4 position knobs. Will I need to use rotary encoders for these?
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Similar Threads

  1. GoFlight still in business?
    By peterkwu in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 03-09-2010, 07:36 AM
  2. Who said it's not a great business!!
    By Jackpilot in forum Cockpit Parts and Motion Platforms
    Replies: 9
    Last Post: 01-08-2008, 12:33 PM
  3. open for business!
    By Bob Reed in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 11-01-2005, 12:38 PM