FSBUS Cant Write CID

[388TH_A]

So in the the CDK i can do a echo test with no problem and no errors. I was able to flash the Controller and it works i can Turn on and off the LEDs on the DO64 but for some reason its stuck on CID 31 default. I cant seem to be able to write the controller to any other CID. I can change the CID in the CDK but to write say CID 7 to the Controller it does it i click the button 3 times like normal ans it says 1, 2, OK but to go test the controller its still stuck on CID 31. Any ideas?

[sgaert]

Do you set the Jumper how it is writen in the manual?

[388TH_A]

There is the 6 pin ISP and the 3 pin int ext power and a 10 pin and thats it there isnt any other jumpers for the DO64

[sgaert]

Read the manual of the DOUT board.

Setup CID
Any FSBUS controller have a CID to identify it in the network.
The value from 1 to 30 can be burned into the ATTINY EEPROM with the Fsbus CDK.
(select [Setup] – [FSBUS setup]).
Usually this is done once in the controllers lifetime. To prevent accidently unwanted changes
of the CID, you need to set a jumper from pin 4 to 6 on the ISP connector J2.
This jumper enables the setup of the controller. After setup you must remove this jumper
again.

[388TH_A]

nope that didnt work for the DO64 its still stuck on ID 31

[sgaert]

strange, that is from the DO64 Board manual and work on my 4 board´s.

[388TH_A]

k so 1 i have the power connected to int 2 i have the 10 pin pluged in 3 then the green light flashes 31 times to show that its CID31 4 i set the jumper from 4-6 5 i go in CDK and click three times to set the CID to 1 6 i take the 4-6 jumper off 7 try testing the DO64 and its still on CID31

[388TH_A]

update so..... I was able to get my 6 pack to be any CIDs i wanted them to be and they work but..... i cant get my DO64 to change from CID31 so i tried moving the Controller from the DO64 and put it into the 6pack and try to give it a CID that way and then put it back and that didnt work grrr Well maybe i can just leave it at 31 since it is working at 31 hehehe

[388TH_A]

Update... So i Started over and redid the COM PCB and that was my problem! Now im able to do any thing i want to do with NO errors!

[sgaert]

Realy good, have fun with your Do64 Board.