Results 1 to 2 of 2
  1. #1
    25+ Posting Member
    Join Date
    Apr 2009
    Location
    Australia
    Posts
    37
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    BU0836X and Rotary Encoders

    Hi All

    I recently purchased a BU0836X board and hasn't it improved my sim in a huge way. I do have a question though. I hooked up 2 x single pole (soon to be replaced by 2 pole) 12 way rotary encoders. I have then caputred the movement on FSUIPC but it's a bit of hit and miss affair when I turn the switch. If I turn it clockwise 4 positions it might move 2 spots and sometimes turns in the opposite direction.

    Any Ideas

    Cheers

    Chris

  2. #2
    150+ Forum Groupie
    Join Date
    Jan 2007
    Location
    Saskatchewan,Canada
    Posts
    255
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: BU0836X and Rotary Encoders

    I had the same problem.
    You have to download and install the small encoder configuration utility from Leo s site. It doesn't have to be running once you configure the rotaries.
    the encoderas worked great after that.

  3. Thanks docmeister thanked for this post

Similar Threads

  1. Rotary encoders for Leo's BU0836X
    By nosecone in forum General Builder Questions All Aircraft Types
    Replies: 5
    Last Post: 11-13-2009, 01:10 AM
  2. Rotary Encoders
    By PittsburghLever in forum General Builder Questions All Aircraft Types
    Replies: 13
    Last Post: 10-04-2008, 04:59 AM
  3. Rotary encoders co-op
    By Paul G in forum Cockpit Parts and Motion Platforms
    Replies: 5
    Last Post: 06-02-2008, 07:08 AM