Results 1 to 5 of 5
  1. #1
    New Member
    Join Date
    Aug 2009
    Location
    Zurich, Switzerland
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    CNC Free Capacity

    Dear All
    We have some free capacity on our CNC (Haase AL 1065, panels max. 1'000 x 650 mm). Cutting either Alu or Plexiglas. Based on your DXF. Please send inquiry if interested.
    Regards, Peter Kruesi

  2. #2
    300+ Forum Addict skino's Avatar
    Join Date
    Nov 2008
    Location
    germany
    Posts
    349
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: CNC Free Capacity

    PM send...

  3. #3

    Re: CNC Free Capacity

    Hi ,
    There is no difference between the components of a machine torch and manual torch for a given machine . So they have the same pierce capability,The machine torch capacity is low due to the inability to rotate the torch into the material .
    My question is has anyone added a torch rotation axis to their CNC plasma in order to pierce like a manual plasma and increase cut capacity accordingly?

  4. #4
    New Member
    Join Date
    Aug 2009
    Location
    Zurich, Switzerland
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: CNC Free Capacity

    Dear Jameshock
    We do not understand your question in this topic ?
    With best regards
    Peter Kruesi

  5. #5

    Re: CNC Free Capacity

    It seems that the best way to make these pieces is a small milling machine with CNC, but until now all we can to find suppliers who tend to make the parts in terms of quantity or models too expensive. Do any of you know of a supplier or source in the Toronto area?

Similar Threads

  1. Free Fmc
    By QF6228 in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 07-06-2010, 07:44 AM
  2. Free Keylogger for mac??
    By siennal in forum Computer Hardware Setup
    Replies: 6
    Last Post: 06-24-2010, 07:59 AM
  3. A very useful free tool for WIN 7
    By Prof Bill in forum Microsoft Windows 7
    Replies: 1
    Last Post: 01-15-2010, 10:11 AM
  4. Free Utility For You
    By AlexJ in forum Computer Hardware Setup
    Replies: 2
    Last Post: 01-04-2010, 04:29 PM
  5. Good old 707.. fmc free
    By GregKeath in forum Pilots Lounge - Let your Hair down
    Replies: 6
    Last Post: 12-24-2009, 06:12 AM