MyCockpit Support Staff
The recipe: Take one small ten buck Kmart travel clock, remove cover and trim hinges,
Start VCarvePro, draw bezel and faceplate, lubricate throat with a beer,
Add a few grams of PVC to CNC table and hold down firmly,
Spin the cutting utensil until cycle stop, then combine the ingredients over work bench,
Give the assemblies three coats of looking at and add more beer whilst grinning!!!
Last edited by Westozy; 03-22-2010 at 08:52 PM.
737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
Supporter of MyCockpit.org, please join me in donating!!!
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
500+ This must be a daytime job
Re: B737 clocks
Nice Work as always Gwyn
Originally Posted by Buddym