Build 410 disaster

[Peter Nielsen]

Hi

You can also add me to the group, as have exact the same problem with 412 and also with 410, it is extremely frustrating.

Peter Nielsen

[xtremeIT]

Hi !

This "route" problem has been there for the last 18 months and has never been fixed.
Enter your route (if you can) on the route page, Activate it and Execute.
From then on its the Legs page where you will have to do everything else.
The Route page will be empty.

I would love Enrico to finally fix this !!

TC

[michelmvd]

There are new updates of the software available in the download section of PM. CDU413g should do the trick.
I can't test it right now, as sim is undergoing a some upgrade works.
A big thank you to Enrico too
B. Rgds
Michel

[xtremeIT]

Hi Michel !

Great to hear about the updates.
Will do a lot of testing over the weekend.

A big thank you to Enrico.
I am a big fan of this software.

TC

[767300]

guys, Its improved, I had the route programmed and went to enter the SID. It wiped the route again leaving what the route had built on the legs page intact. All that was left on the route was the SID and Transition. In the air now so will retry again tomorrow on the return led from TNCM-KATL.

James

[767300]

Ok reflew the same route. Route just disappears after a while. Then 2HRS 33MINS into the flight the entire CDU screen went blank. would not answer to any key input. Had to restart the software after putting the aircraft into speed hold and Heading select. Working as I type but the route page still only shows SID and STAR. another thing is the fuel prediction for arrival has been showing 0 for some time now on this flight even though I will land with 6 tons.

James

just solved the fuel prediction problem, on the CRZ page CRZ speed was showing IAS instead of Mach number, I had selected .80 on setup but its reverting to IAS. Just overwrote with the M number and fuel pred works on Progress page....

[767300]

I have mailed PM support with my findings. Has anyone noticed an intermittent problem with the Approach page, it some times goes to a different page alltogether, I have to press the offset LSK to get Approach sometimes.

Regards

James

[michelmvd]

I had the route programmed and went to enter the SID. It wiped the route again leaving what the route had built on the legs page intact. All that was left on the route was the SID and Transition.
James

Hi James, I can't test the new build as my cockpit is in "maintenance" mode. But I don't think you must program the full route and then enter the SID.

First set Origin / Destination
Dep RWY
SID
rest of routing
STAR

Normally after entering the STAR, the route was gone in the RTE page. In the LEGS page everything was always ok.

B. Rgds
Michel

[767300]

Hi Michael, yit is all working up to the point where I have to change departure runway sid as per ATC or weather. Its all there on the legs but the route is still giving problems. Putting together a route and will mail all results to Enrico. I will post back findings.

James

[snooker]

Hi,
Same problem + CTR point in LEG PAGE U/S - Nothing on GC.

Waiting for new release.

Rgds.

Seb