Results 1 to 2 of 2
  1. #1
    75+ Posting Member davek's Avatar
    Join Date
    Jan 2008
    Location
    FNQ Australia
    Posts
    139
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    CNC compiler problem

    Hey Gwyn

    Did you have any problems with the compiler for your cnc software.

    I try to import my vcarve or any gcode into my cnc driver program and it imports about 90% then the program stops working.

    I have done everything on the web site and downloaded all the new up dates for vista etc and still no joy.

    Wondering if you had a similar problem

    Machine CNCShark
    Software V carve pro
    CNC shark Basic Panel - this is the drama queen causing the problems
    thanks
    Dave

  2. #2
    75+ Posting Member davek's Avatar
    Join Date
    Jan 2008
    Location
    FNQ Australia
    Posts
    139
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: CNC compiler problem

    Cancel the above. I realised that I had the SD Card in the computer instead of in the controller box.

    Now its working fine.

    Just waiting on the fine bits to arrive. Tried on a piece of mdf with a 3mm bit which cut out the holes and outline ok. Just destroyed the text..

Similar Threads

  1. ATC PROBLEM
    By manhattan in forum General Builder Questions All Aircraft Types
    Replies: 9
    Last Post: 04-11-2011, 04:54 AM
  2. FSX and FS9 problem
    By mvc340 in forum General Builder Questions All Aircraft Types
    Replies: 1
    Last Post: 05-28-2010, 06:58 AM
  3. SIOC Pre compiler
    By MrRoper in forum OpenCockpits General Discussion
    Replies: 35
    Last Post: 10-18-2009, 10:00 PM
  4. Ias Problem
    By AchillesP in forum PM General Q & A
    Replies: 7
    Last Post: 07-16-2008, 02:25 PM