Results 1 to 2 of 2
  1. 12-09-2009, 12:13 PM #1
    trudelking
    trudelking is offline
    New Member
    Join Date
    Jul 2008
    Location
    Germany
    Posts
    4
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Learjet Rudder Pedal Dimensions

    Hi folks,

    i am currently in the phase of planning a lear sim. I chose the Lear because it is not too complicated to build and there is quite a lot of information about it on the web already.
    However, I can't find any source of dimensional information about the rudder pedals.
    I was able to get the approximate proportions with the help of the flight manual and my CAD software.

    Maybe some of you guys have the possibility to get that information, maybe even on the real thing.

    I'm still missing the the measures shown on the following picture.
    Learjet Rudder Dimensions.JPG

    Thank you already.
    Reply With Quote Reply With Quote
  2. 12-09-2009, 02:35 PM #2
    Tomlin
    Tomlin is offline
    1000+ Poster - Fantastic Contributor Tomlin's Avatar
    Join Date
    Nov 2005
    Location
    Waycross, GA
    Posts
    1,027
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Learjet Rudder Pedal Dimensions

    Private Message sent.
    Eric Tomlin-
    Learjet 45 Builder
    www.flightlevel180.org
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Rudder Trim - Does it physically move the center of the rudder?
    By Ronson2k9 in forum General Aviation (GA) Builder Disccusion
    Replies: 6
    Last Post: 09-30-2010, 07:00 PM
  2. Boeing rudder pedal conversion
    By jsfboat in forum Westozy's Mechanical Engineering
    Replies: 10
    Last Post: 06-18-2010, 09:48 AM
  3. 737 Rudder Pedal on Ebay
    By Fly_AB in forum Off Site Articles For Sale
    Replies: 0
    Last Post: 09-13-2009, 09:57 AM