11-12-2009, 06:39 AM #1
problem with cockpitsonic flaps instrument breakout board - spd brk extended
i use the flapsinstrument from cockpitsonic and also the "breakout board" (FS2004, PM software)
Until driver 0.9817 the speed brake extended LED works fine. With newer driver versions i see the light "ON" only with flaps 45 and regardless of handle position.
I did not change the wireing. I also asked cockpitsonic if the had changed the wireing, but they didnīt.
To ckeck if my wireing is still ok, i installed again version 0.9817.
Ok, some overhead Instruments were not working anymore, because i newer driver is needed for them, but the spd brk extended LED worked correctly.
So is anyboby using the hardware together with the newest driver ?
If yes, how is the spd brk extended LED working?
greetings from Willich
my Boeing 737 Simulator Project
By kozak737 in forum MyCockpit Support:Replies: 14Last Post: 11-11-2009, 02:15 PM
By richard hutchinson in forum I/O Interfacing Hardware and SoftwareReplies: 2Last Post: 08-15-2009, 11:47 AM
By airbus319 in forum I/O Interfacing Hardware and SoftwareReplies: 1Last Post: 01-19-2009, 09:28 AM
By Per Alm in forum I/O Interfacing Hardware and SoftwareReplies: 4Last Post: 01-25-2008, 09:39 AM
By hercules in forum PM General Q & AReplies: 7Last Post: 03-07-2007, 01:12 PM