Results 1 to 2 of 2
  1. #1
    150+ Forum Groupie spiro's Avatar
    Join Date
    Jan 2009
    Location
    greece
    Posts
    286
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    opencockpits master card j2 output qestion

    hi guys
    i have dicided to go with opencockpits on interfacing i am reading about how to connect inputs and out puts there is one part of the outputs that i dont understand and wondering if some one can help out i dont have the card yet so it will be a bit harder
    j2 are the out puts and pin 1 is the possitive and 2 negetive say i whant a push button when presset a led to light the push button will be a input on the j3 first group 001 and its ground how do i conect the led to j2 so it will light???i read a titorial on the sight but did not understand it do i use one of the out puts and groung from j2 or the 5volt positive and one of the out puts on j2???

  2. #2
    500+ This must be a daytime job kiek's Avatar
    Join Date
    Jan 2007
    Location
    Netherlands
    Posts
    698
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: opencockpits master card j2 output qestion


Similar Threads

  1. opencockpits usb output card prob?
    By jonnydaz53 in forum OpenCockpits General Discussion
    Replies: 22
    Last Post: 03-15-2013, 04:32 AM
  2. Replies: 1
    Last Post: 04-03-2011, 12:32 AM
  3. Questiong about soldering / OpenCockpits Master Card help needed
    By pi1er in forum General Builder Questions All Aircraft Types
    Replies: 8
    Last Post: 11-25-2009, 05:38 PM
  4. IO Cards Problem setting up Display Card on Master Card
    By Barrykensett in forum OpenCockpits General Discussion
    Replies: 1
    Last Post: 05-02-2009, 01:30 PM
  5. i/o card qestion
    By spiro in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 04-04-2009, 03:22 AM