Thread: CDU PLN STEP and ABM not working
10-16-2009, 03:01 PM #1
- Join Date
- May 2007
CDU PLN STEP and ABM not working
I'm trying Magenta software on my system to be expert in a bit, but I have a problem on the CDU about STEP command and ABM.
The software versions I have are 406 for CDU and 438 for MCP .
When I run on MCP setting PLN command it normally appears on the CDU LEGS the CTR word written on the first line, but after I'm unable to move it down to the other Waypont legs because on 6 right key I have RTE and not STEP command.
Finally, when active FIX page I get all the data correctly on CDU and ND, I'm not able to work the ABM command nor to get any data (even in flight)
We precise that my system has WideView and FS9 on the server (which runs FS in the background) together with the CDU and MCP CPFlight, while PFC and ND are on a client.
The system NetDir and everything other commands work perfectly except the two commands that I have reported.
I tried to reinstall CDU and MCP upagrade but no change.
Thank you for your replays
10-17-2009, 06:14 AM #2
Re: CDU PLN STEP and ABM not working
Check this with PM support.
By blueskydriver in forum Cockpit SoundsReplies: 11Last Post: 02-28-2011, 03:09 PM
By cornleader in forum Welcome to MyCockpit New here? Introduce Yourself!Replies: 5Last Post: 06-01-2010, 03:46 PM
By props in forum MyCockpit Support:Replies: 8Last Post: 08-07-2009, 12:45 AM
By mwilliams6275 in forum Phidgets & Cockpit Simulator BuilderReplies: 1Last Post: 04-02-2006, 07:52 AM
By Enrico Schiratti in forum PM General Q & AReplies: 0Last Post: 11-23-2004, 07:57 AM