Results 1 to 2 of 2
  1. #1
    25+ Posting Member shafian's Avatar
    Join Date
    Sep 2008
    Location
    Hobart, Australia
    Posts
    37
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    e37 with OC master

    Hi everyone,

    My apologies if this has already been discussed. In which case, I would greatly appreciate if someone could point me to that thread as I have done an exhaustive search but couldn't find anything on this topic.

    Anyway my question is quite simple.. Does anyone know whether the E37 dual concentrics work with the OC master ? I was looking at the data sheet and comparing it to the cts 288 encoder although not dual concentric but the specs look alike. However rather than jumping the gun and ordering any from leo bodnars website.. I wanted to get some advice.

    Happy simming
    Shafian

  2. #2
    75+ Posting Member Leo Bodnar's Avatar
    Join Date
    Apr 2008
    Location
    UK
    Posts
    95
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: e37 with OC master

    Hello Shafian,

    ELMA E37 produces two pulses per notch while CTS288 generates only one. Unfortunately I have not personally used OC hardware so I cannot give exact verdict but from some forum discussions that I have come across I understood that OC only works with CTS288 style input. I have seen that someone tried to get around this using OC software (I think it is SIOC) but it was not working properly as rotation speed increased. This is all I know so far...

    Cheers
    Leo

Similar Threads

  1. Master Caution / Master Warning lights using FS2Phidget5 (noob)
    By mhayling in forum Phidgets & Cockpit Simulator Builder
    Replies: 3
    Last Post: 05-18-2010, 02:08 PM
  2. Oc master 64 outputs???
    By shafian in forum I/O Interfacing Hardware and Software
    Replies: 13
    Last Post: 11-12-2008, 08:47 AM
  3. Master BATT and Master Avionics confusion
    By Tomlin in forum PM RJ GC
    Replies: 4
    Last Post: 08-25-2008, 09:03 AM
  4. LED:s to master card
    By Jouni in forum I/O Interfacing Hardware and Software
    Replies: 1
    Last Post: 12-10-2006, 09:29 PM