Thread: Inhibit for x amount of seconds?
09-03-2009, 10:04 AM #1
Inhibit for x amount of seconds?
I am trying to write some SIOC logic for the Glideslope Inhibit indicators on my MIP. From what I understand, every time you are below the glideslope, this annunciator lights up and you can push it, in order to shut it down.
Now, my question is... Once you push it, it shuts it off but will it light up immediately again, since technically you are still under the glideslope?
How can I program the logic so that as soon as you push it, it will keep it off for say 30 seconds? This gives you time to adjust your approach and fall back within the glideslope.Regards,
Efrain "E" Ruiz (HondaCop)
LiveDISPATCH @ http://www.livedispatch.org
09-03-2009, 10:25 AM #2
- Join Date
- Jul 2013
Re: Inhibit for x amount of seconds?
Try this site
By Chaser in forum Off Site Articles For SaleReplies: 1Last Post: 10-21-2010, 10:20 AM
By ekezz in forum Dodiano's Airbus ForumReplies: 2Last Post: 03-23-2006, 10:22 AM
By JAMES WEBSTER in forum PM General Q & AReplies: 6Last Post: 03-02-2006, 10:40 AM
By Peter Parnreiter in forum PM General Q & AReplies: 0Last Post: 02-10-2006, 10:06 AM
By Enrico Schiratti in forum PMSystemsReplies: 0Last Post: 02-08-2006, 05:07 AM