Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie
    Join Date
    Jun 2008
    Location
    Stafford, UK
    Posts
    161
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Boeing Annunciator Fabrication

    Hi Captains.

    I have been having some good results with my CNC router recently, wish I had a camera!

    I have built some of my 767 MIP and I now want to build some annunciators for it.

    I gather that the usual way to make them is to use clear Acrylic, paint it black and engrave the legend onto it so that the light can shine through the letters.

    The problem with that is that the legend is always visible whether it is lit or not and I have a real 767 engine start panel and have noted that when the annunciators are not lit you cannot see what the legend is.

    Does anyone know if or how I can achieve this? I want my annunciators blank when they aren't lit if I can do it. (If not I suppose I can live with it!)

    Thanks.
    Tom.

  2. #2
    500+ This must be a daytime job ian@737ng.co.uk's Avatar
    Join Date
    Jan 2006
    Location
    Oswestry, Shropshire
    Posts
    609
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Annunciator Fabrication

    hello tom....
    have you thought about using the black face as the back of the annunciator and engraving that (back to front of course )
    i have two symulatory panels done like that and when not backlit the legends are pretty well un-noticeable.....
    just a thought.
    rgds ... ian
    Mr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.

    www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
    FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge

  3. #3
    150+ Forum Groupie
    Join Date
    Jun 2008
    Location
    Stafford, UK
    Posts
    161
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Annunciator Fabrication

    Hi Ian.

    Thanks for the tip. Even if it doesnt work it wont cost me a lot to find out.

    Im off to order some plastic!

    Tom.

Similar Threads

  1. PCB Fabrication
    By Jordan Farmer in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 07-21-2010, 01:24 PM
  2. 737 annunciator legend?
    By GregKeath in forum MyCockpit Support:
    Replies: 2
    Last Post: 08-31-2009, 09:08 PM
  3. Annunciator colors?
    By HondaCop in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 07-11-2009, 12:10 PM
  4. Annunciator Switches?
    By asdineen in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 02-15-2009, 04:37 PM
  5. Annunciator finished
    By spitfire9 in forum My Cockpit Update
    Replies: 10
    Last Post: 05-10-2008, 04:39 PM