Results 1 to 2 of 2
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    May 2009
    Location
    Germany
    Posts
    6
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    programming radio with FSUIPC

    Hey,

    I have another question concerning the offsets of FSUIPC.
    If I have pushbuttons and a rotary, is it possible to simulate the radio of an aircraft?

    I want to realize a little radio section. With the pushbuttons I select the frequency I want to change and with two rotaries I change the frequency.

    Are there any offsets to realize that with the FSUIPC? I use the BU0836X card and have serveral pushbuttons and two rotaries connected. How can I select a source and how can I change the frequency? Is there a radio increament and decreament? The only thing i Found was a COM incrament and NAV increament but I only have to rotaries. Is there any solution?

    A last pushbutton is used to swap the frequency between standby and active.

    Finally, it should work like the Radio Management Panel of an Airbus.
    It would be perfect if I can change NAV1, COM1, ADF1 and XPNDR

    Is it actually possible to use a Software to program such ideas? I know SIOC, but can SIOC work with other hardware then IOCards?

    Is there a way to use SIOC with the BU0836x?

    A lot of questions, I know, but I hope you can help me

    Benjamin

  2. #2
    300+ Forum Addict Anderson/SBSP's Avatar
    Join Date
    Aug 2008
    Location
    São Paulo, Brazil, Brazil
    Posts
    336
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: programming radio with FSUIPC

    SIOC not control other hardwares, just IOCards.

Similar Threads

  1. Programming Help Needed Please
    By simulatorpilot in forum Computer Hardware Setup
    Replies: 2
    Last Post: 11-22-2010, 08:36 PM
  2. Programming CDU
    By Martin Cumming in forum Westozy's Mechanical Engineering
    Replies: 0
    Last Post: 11-16-2009, 04:52 PM
  3. Programming a Route?
    By Sean Nixon in forum PM Boeing FMC/CDU
    Replies: 5
    Last Post: 11-16-2009, 12:35 PM
  4. programming Opencockits FMC?
    By Mathias357 in forum I/O Interfacing and Hardware
    Replies: 3
    Last Post: 10-13-2009, 09:00 AM
  5. C# programming and Simconnect
    By kranky in forum I/O Interfacing Hardware and Software
    Replies: 2
    Last Post: 05-14-2009, 07:51 PM