Results 1 to 2 of 2

Thread: Feedback

  1. #1
    Executive Vice President, Administration, MyCockpit, Inc.
    Join Date
    Jun 2009
    Location
    Bangalore
    Posts
    287
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Feedback

    Dear Friends

    I am doing some research about my home cockpit setup. I noticed some reliable vendors flyengravity and they have been very good. This morning I noticed another supplier Opencockpit. Their prices seem to be a lot lower than Engravity. For instance pedestal bay in Opencockpit is 299Euro as against 699 Euro in engravity.

    What is your feedback on opencockpit. Which one is better or what are the pros and cons.

    Appreciate your help

    Regards

  2. #2
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,432
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Feedback

    No Comparison at all. Engravity Quality is 100% like the real thing. OpenCockpits is a cheaper solution yes, but you get what you pay for. Not to mention, the support behind Engravity Products is the best I have ever seen.



    Trev
    ________________________
    Trevor Hale

Similar Threads

  1. Article feedback?
    By geneb in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 07-22-2010, 01:06 PM
  2. Feedback & “close loop” sys.
    By Mirage in forum Cockpit Parts and Motion Platforms
    Replies: 0
    Last Post: 11-13-2009, 10:33 AM
  3. Some feedback please...
    By andreotti60 in forum Video Interfacing and Hardware
    Replies: 4
    Last Post: 06-05-2009, 04:22 AM
  4. CockpitSonic feedback
    By PittsburghLever in forum MyCockpit Support:
    Replies: 3
    Last Post: 05-20-2009, 03:44 PM
  5. Aerodeckengineering feedback
    By giodoca in forum Cockpit Parts and Motion Platforms
    Replies: 3
    Last Post: 05-20-2007, 04:03 PM