Results 1 to 2 of 2

Thread: DIY - Korry latching switch

  1. #1
    150+ Forum Groupie Perik's Avatar
    Join Date
    Aug 2007
    Location
    NORWAY
    Posts
    206

    DIY - Korry latching switch

    Hello

    This has certainly been done before, but I would just like to show you one way of making a latching switch.
    Though I have a CNC, it is not necessary to get this to work, but it helps a lot.
    I was looking for a latching switch with a travel of 7-9mm, but that was not easy to find so why not use a ballpoint.
    I have not touch the original “Korry 433” or some of the other 1” Korry stuff,
    but if you look at a ballpoint I believe it’s action is quite the same as the Korry.
    With some modification and in my case adding a small PCB, I ended up with this prototype.

    The PCB is carrying a Microswitch, two LED’s (not mounted), three resistors and a transistor (for light intensity control)
    The nice thing is that the Microswitch with the Lexan spring gives me a true state of the switch – toggle action.

    More info if needed....

    Attached Images Attached Images
    Last edited by Perik; 06-26-2009 at 07:40 AM. Reason: Updated the link
    Regards,
    Per-Erik
    www.hoddo.net

  2. #2
    300+ Forum Addict
    Join Date
    Mar 2007
    Location
    Norway
    Posts
    462
    Very nice. Good job done there. Thanks for sharing

Similar Threads

  1. Which korry switch/switches does the a320 use?
    By ScottyPcGuy_03 in forum Cockpit Parts and Motion Platforms
    Replies: 3
    Last Post: 11-18-2011, 10:55 PM
  2. "Real" Korry switch, about 2 dollar max.
    By Hessel Oosten in forum Cockpit Parts and Motion Platforms
    Replies: 9
    Last Post: 12-21-2010, 02:39 PM
  3. My quick & easy Korry Switch
    By Polmer in forum Where to Start Building a Home Cockpit
    Replies: 0
    Last Post: 10-15-2009, 07:49 PM
  4. Overhead korry switch click
    By sstusek in forum Dodiano's Airbus Forum
    Replies: 6
    Last Post: 03-08-2009, 11:46 PM
  5. A/T - Latching Switch
    By Induced_Drag in forum I/O Interfacing Hardware and Software
    Replies: 4
    Last Post: 10-27-2008, 06:40 AM