Results 1 to 2 of 2
  1. 04-29-2009, 05:05 AM #1
    bsv118
    bsv118 is offline
    10+ Posting Member
    Join Date
    Feb 2009
    Location
    italy
    Posts
    22
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    SIOC and LevelD 767

    Hi all
    I have just a little problem: I have a SIOC that work fine with MCP and EFIS USB on PMDG 737; I should want to use these modules with LevelD 767; so I have copied my sioc and following instructions from Niko Kaan (a great) I have adapted this to 767.
    When I launch leeksecon appear an error message ( sioc is a wrong version); but if I rename original sioc and rename the copy as IOCARD all works very well.
    My question is: what I must make for no rename this sioc evrytime?
    Thanks to all
    Stefano
    P.S. excuse me for my bad english
    Reply With Quote Reply With Quote
  2. 05-05-2009, 08:13 AM #2
    bsv118
    bsv118 is offline
    10+ Posting Member
    Join Date
    Feb 2009
    Location
    italy
    Posts
    22
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I respond to myself
    I have solved the problem and i post it if may be helpfull for anyone.
    Name IOCards the carpet for LevelD 767 and rename IOCards1 (and SIOC1) the carpet for PMDG 73.
    All work very well.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. LEVELD on two computers, possible?
    By stabell in forum Computer Hardware Setup
    Replies: 7
    Last Post: 10-31-2008, 08:18 PM
  2. Openc. CDU works with LEVELD?
    By stabell in forum OpenCockpits General Discussion
    Replies: 3
    Last Post: 10-15-2008, 07:58 AM
  3. Led Pushbuttons with LevelD 767
    By Drewsta in forum I/O Interfacing Hardware and Software
    Replies: 1
    Last Post: 07-06-2008, 07:24 PM