Results 1 to 5 of 5

Thread: Fcu 286

  1. #1
    75+ Posting Member
    Join Date
    Nov 2005
    Location
    Helsinki - Finland
    Posts
    151
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Fcu 286

    Hello,
    Just wanted to ask how is this new FCU 286 update working with
    other simmers? I have some problems at approach phase.
    The Aircraft (project airbus A320) sometimes suddenly goes up like it
    tries to perform toga ?

  2. #2
    75+ Posting Member
    Join Date
    Nov 2005
    Location
    Helsinki - Finland
    Posts
    151
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Well,well...

    It seems that I might be the only
    Airbusdriver that updated to newest
    Versions? Who else is flying airbus?

  3. #3
    150+ Forum Groupie pdpo's Avatar
    Join Date
    Nov 2005
    Location
    belgium
    Posts
    280
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hi there,

    I have been using this FCU too and did not notice problems on apprach. The only odd thing
    I have experienced is that just after takeoff the engines go to idle and then start spooling
    up again to TOGA thrust very slowly. In order not to crash the plane I need to intervene
    and level out or even start to descend slowly to let the speed increase again.
    As the engines regain thrust I can start climbing again. Send email to enrico about it.
    Lately I have been very busy and did not fly a lot so more on this in the future

    Greetz Peter
    FS9+PM+AST+opencockpits

  4. #4
    75+ Posting Member
    Join Date
    Nov 2005
    Location
    Helsinki - Finland
    Posts
    151
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    same here

    Thanks for a reply. I also have experienced this behaviour
    after TO. Approximately 600 passengers have been killed so far.
    If You noticed, when you add those numbers to the corresponding
    gate detent there is wider scale. Before ti was 0-100 and now it is
    from 16383-0. This gives me better feedback from a throttle, but
    caused propably some problems with my Saitek hardware. Strange
    thing is that once I got all calibrated/configured via FSUIPC/FSX next time I start FSX the throttle is not working good any more? For example from 16383 it comes down good but in the middle of the lever movement, values goes up more than 50000? that means A/T goes TOGA etc. Are You using SIOC by the way?

  5. #5
    10+ Posting Member explora's Avatar
    Join Date
    Sep 2007
    Location
    france
    Posts
    13
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hello
    I have the same problem with the throttle gate.Beofre with FCU282 no problem but now there is a bug.So I come back to 282 for moment .I think we must to send mail to PM support.